868MHz 4 channel receiver

1.Easy installation, easy maintenance 2.Support various switching modes 3.Up to 4 outputs 4.Control various electric devices. 4 Channel ReceiverOverview

The 4 Channel Receiver receives wireless signals from YTL wireless sensors and switches and provide 4 relay outputs, which are grouped into 1 cases. The connection from the receiver to actuator(relay case) uses network Cat 5 cable. 4 lighting circuits can be controlled by the receiver. Multiple receiver scan form a control network using CAN-Bus system. Computers can also be connected to the control network to query information from the receivers or send control commands to them. In this way, a centralized control can be implemented. Receivers may be installed above ceiling or inside electricity distribution box. There are 2 buttons on a receiver, one is used to make the receiver go into learning mode, and the other is used to clean up the learned information. It has the following characteristics:

l   Each receiver has a separate microprocessor, is the most advanced distributed control system.

l   Various switching modes are supported, such as delay on/off

l   The receiver has various control logic built in.  Besides lights, it also can provide controls devices like curtain and HAVC

Scope of Use

This product can be used in offices, hotels, schools, homes, factories, hospitals, municipal buildings, and other indoor places.

Parameters

l   Standards-compliant: Q/67218248-4.1-2009

l   Working Volt:AC 100V~265V,50Hz/60Hz

l   Working Frequency: 868.3MHz/315.0MHz

l   Output: 4 channel relay output.

l   Working Temperature: -10°C~60°C, Relative Humidity≤75%,

l   Dimensions: 149mm×90mm×60mm

l   Material: Fire-Retardant Material ABS

l   Protection Type IP30, only available for indoor.

l   Position of Installation: can be installed into electricity distribution box, external antenna may be connected (the length of antenna is 2.5m - 4m).

Points for Attention

l   The temperature of receiver is -10°C~60°C. Power AC100V~265V, 50Hz/60Hz; Use the product out of the scope may cause abnormal work or damage equipment.

l   The product is for indoor use only. Avoid dust, moisture, corrosion.

l   The product should be installed and used to the place that is non-shake, non-vibration. The position of antenna should far away from metal and other radio devices or devices generating electric noises

l   Avoid electric shock, non-professional people can’t unpack the receiver.

868MHz 4 channel receiver